- #External solid state drive for imac how to#
- #External solid state drive for imac install#
- #External solid state drive for imac full#
- #External solid state drive for imac free#
This took me 10 minutes of frustration and I had to stand the iMac back up to do it and see what I was doing. Now that the cable is installed, carefully slide the motherboard back into its original place. Plug in your 13 pin female SATA plug into the SPARE and route it towards the DVD drive. Now underneath the top side of the motherboard is the hard drive SATA connector and a SPARE SATA connector. Once the IR sensor is out of the way, slide the motherboard out carefully and lift it up slightly to gain access to the connectors underneath. Now if you haven't done so already, remove the IR sensor under the Apple logo.
#External solid state drive for imac how to#
STEP 6 describes how to slide out the motherboard. Then disconnect the DVD drive (ODD) and set it aside as well. Now disconnect the 1TB hard drive and remove it. You cant see them from this picture, but they are just underneath. The blue bullseye represents where the SATA connectors are just underneath the motherboard.
#External solid state drive for imac free#
Be careful! Wires are still attached to the back chassis so just move it over for now so it is free from the motherboard. First use a T6 to unscrew the one screw marked in the pink box. Remove this wifi device (marked in pink) from the motherboard.
It does not require much effort to lift the glass. Be careful, the suction cup I used here left slight residue. Use a suction cup to remove the front glass of the iMac.
See below for more information on adding memory.Īlso, by completing this step first, the motherboard will be more maneuverable, and you may not need to disconnect all the connectors listed in STEP 5. I will list this step as optional because it is not required, but may be helpful. Although I did not do this, it is probably a good suggestion, as I did have trouble sliding the motherboard back into its orginal position. This helps when repositioning the motherboard. Some people that have followed this guide recommend removing the memory (RAM) modules first. However, if you are looking for ultimate performance, I'd go with the new Samsung 830 Series. The m4 has great performance and is more affordable.
#External solid state drive for imac full#
When chosing an SSD, be sure its SATA-III to take full advantage of data throughput. NOTE: The SSD shown in this guide is the older Crucial model (C300), which only acheives half the speed of the newer Crucial m4s. I purchased mine from Adorama for much less, also consider Amazon. Apple will charge you $1699 for this model + tax. I purchased the iMac 27" base model (MC813LL/A), which comes with a 2.7Ghz processor, 4GB of memory, and a 1TB hard drive. Performing the actions herin may void Apple's warranty. This procedure is intended for educational purposes. Although it may be different for a 21.5" iMac, I know it is possible, as I read that many people have had success across the web.
#External solid state drive for imac install#
This procedure was performed on a 27" iMac which has slightly more room to install an SSD. Once the SATA cable is installed, it is easy to install and securely mount an SSD drive under the DVD drive.
The iMac has two SATA-III connectors, one is already in use by the orginal 1TB hard drive.
The procedure requires some dis assembly to connect a SATA cable to the spare SATA-III connector located underneath the motherboard. This is not a replacement for the original hard drive, but instead an addition. This procedure explains how to install an SSD. The total time to complete is 3 hours approximately. Some prior computer experience is recommended along with patience. And after installation, you'll feel more comfortable with your iMac hardware. To install an SSD on a 2011 Apple iMac is not easy, but not hard either.
0 kommentar(er)
